Nortel Networks Meridian NT5D21DA REL11 Intelligent Peripheral Equipment
Removed From A Working Environment, no passwords or system logins known
Please note you will need to have technical knowledge on how to install and set up this phone system or have a Telecoms installer who will be able to before you can use this system.
- NTCK43AB x 3 // 2MB Digital DPRI Card
- NT8D04BA x 2 // The Nortel NT8D04BA is a Meridian phone cabinet card for the Meridian 1 system. The NT8D04BA provides connection to intelligent peripheral shelves. The Meridian NET superloop card connects shelves between Meridian 1 cabinets.
- NT8D17HA // Nortel Conference TDS Module Card
- NTRB33AD // Fiber Junctor Interface FIJI Card
- QPC43K // Peripheral Signal Card
- QPC441F // 3-Port Extender 3PE Cabinet Interface Card (''Port 0 on the 3PE card in each Core/Network Module extends the interprocessor bus to the interface section on the backplane, not to a network loop.'')
- NT5D03PB - CP 6060E / 160MB - 64 FLASH / 64 DRAM
- NT6D41GA - 10DU/C
Digital Line Card:
A digital line card is an intelligent peripheral equipment (IPE) device which can be installed in the IPE module. It provides 16 voice and 16 data communication links between a Meridian 1 switch and modular digital telephones.
The digital line card supports voice only or simultaneous voice and data service over a single twisted pair of standard telephone wiring. When a Meridian digital telephone is equipped with the data option, an asynchronous ASCII terminal, or a PC acting as an asynchronous ASCII terminal, can be connected to the system through the digital telephone.
Digital line cards are housed in the Intelligent Peripheral Equipment (IPE) Modules. Up to 16 cards are supported.
The digital line card circuitry is mounted on a 31.75 cm by 25.40 cm (12.5 in by 10 in) double-sided printed circuit board. The card connects to the backplane through a 160-pin edge connector. The faceplate of the digital line card is equipped with a red LED that lights when the card is disabled.
When the card is installed, the LED remains lit for two to five seconds as a self-test runs. If the self-test completes successfully, the LED flashes three times and remains lit until the card is configured and enabled in software, then the LED goes out. If the LED continually flashes or remains weakly lit, replace the card.
The digital line card is equipped with 16 identical digital line interfaces. Each interface provides a multiplexed voice, data, and signaling path to and from a digital terminal (telephone) over a 2-wire full duplex 512 kHz Time Compression Multiplexed (TCM) digital link. Each digital telephone and associated data terminal is assigned a separate Terminal Number (TN) in the system database, giving a total of 32 addressable units per card.